Honeywell vx6 Reference Manual page 108

Message
Switching to admin-
backdoor
Switching to admin-
hotkey press
Switching to admin-
kbdhook.dll not found
Switching to admin-
keyboard hook
initialization failure
Switching to admin-
registry read failure
Switching to
TaskbarScreenMode
Switching to user mode
Switching to user-hotkey
press
Taskbar hook failure
Taskbar hook OK
Timeout looking for app
window
ToUser after admin, not
at boot
ToUser after admin-app
still open
ToUser after admin-no
app or cmd line change
Unable to move desktop
Unable to move taskbar
Unhook taskbar wndproc
failure
Unhook wndproc failure
Unhooking taskbar
3-56
Explanation and/or corrective action
The system is currently in user mode and is now switching to admin mode. The
switch occurred because of the backdoor key presses were entered by the
administrator.
The system is currently in user mode and is now switching to admin mode. The
switch occurred because of a hotkey press by the administrator.
The keyboard hook load failed, so AppLock switches to admin mode. If a password
is specified, the password prompt is displayed and remains until a valid password is
entered.
If the keyboard hook initialization fails, AppLock switches to admin mode. If a
password is specified, the password prompt is displayed and remains until a valid
password is entered.
See the explanation of the "Registry read failure" above. AppLock is switching into
Admin mode. If a password has been configured, the prompt will be displayed and
will not be dismissed until a valid password is entered.
In administration mode, the taskbar is visible and enabled.
The registry was successfully read and AppLock is starting the process to switch to
user mode.
The system is currently in admin mode and is now switching to user mode. The
switch occurred because of a hotkey press by the administrator.
AppLock is unable to control the taskbar to prevent the locked application from re-
enabling it.
AppLock successfully installed control of the taskbar.
After the application is launched, AppLock must wait until the application has
initialized itself before proceeding. The application did not start successfully and
AppLock has timed out.
The user mode switch is attempted when the device boots and after the
administrator presses the hotkey. The mode switch is being attempted after a hotkey
press.
The switch to user mode is being made via a hotkey press and the administrator has
left the application open and has not made any changes in the configuration.
If user mode is being entered via a hotkey press, the administrator may have left the
configured application open. If so, AppLock does not launch the application again
unless a new application or command line has been specified; otherwise, it just
locks it.
The desktop is moved when switching into user mode. This prevents them from
being visible if the application is exited and restarted by the timer. This error does
not affect the screen mode switch; processing continues.
The taskbar is moved when switching into user mode. This prevents them from
being visible if the application is exited and restarted by the timer. This error does
not affect the screen mode switch; processing continues.
AppLock could not remove its control of the taskbar. This error does not affect
AppLock processing
AppLock could not remove the hook that allows monitoring of the application.
In administration mode, the taskbar should return to normal operation, so AppLock's
control of the taskbar should be removed.
Level
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_
PROCESSING
LOG_EX
LOG_
PROCESSING
LOG_
PROCESSING
LOG_ERROR
LOG_EX
LOG_ERROR
LOG_EX
LOG_EX
LOG_EX
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_ERROR
LOG_EX