Bluetooth Indicators; Bluetooth Barcode Reader Setup; Prerequisites - Honeywell vx6 Reference Manual

Bluetooth Indicators

The Bluetooth taskbar Icon state changes as Bluetooth devices are discovered, paired, connected and disconnected.
There may be audible or visual signals as paired devices re-connect with the VX6.
Taskbar Icon Legend
VX6 is connected to one or more of the targeted Bluetooth device(s).
VX6 is not connected to any Bluetooth device.
VX6 is ready to connect with any Bluetooth device.
VX6 is out of range of all paired Bluetooth device(s). Connection is inactive.
Note: When an active paired device enters Suspend Mode, is turned Off or leaves the VX6 Bluetooth scan range, the
Bluetooth connection between the paired device and the VX6 is lost. There may be audible or visual signals as paired
devices disconnect from the VX6.
AppLock, if installed, does not stop the end-user from using Bluetooth applications, nor does it stop authorized Bluetooth-
enabled devices from pairing with the VX6 while AppLock is in control.

Bluetooth Barcode Reader Setup

Please refer to the Bluetooth scanner manufacturer's User Guide; it may be available on the manufacturer's web site. Contact
Technical Assistance for Bluetooth product assistance.
Honeywell supports several different types of barcode readers. This section describes the interaction and setup for a mobile
Bluetooth laser scanner or laser imager connected to the VX6 using Bluetooth functions.

Prerequisites

The VX6 has the Bluetooth hardware and software installed. An operating system upgrade may be required. Contact
l
Technical Assistance
If the VX6 has a Bluetooth address identifier barcode label affixed, then Bluetooth hardware and software is installed.
l
The mobile Bluetooth laser scanner / laser imager battery is fully charged.
l
The VX6 is connected to AC or DC (vehicle) power.
l
The barcode numbering examples in this segment are not real and should not be created nor scanned with a Bluetooth
l
scanner.
To open the LXEZ Pairing program, tap Start > Settings > Control Panel > Bluetooth or tap the Bluetooth icon on the
l
desktop or tap the Bluetooth icon in the taskbar.
Locate the barcode label, similar to the one shown above, attached to the VX6. The label is the Bluetooth address identifier for
the VX6.
The mobile Bluetooth scanner / imager requires this information before discovering, pairing, connecting or disconnecting can
occur.
for details.
3-75