Lexmark X746de Service Manual page 263

200–201 paper jams
Open the upper front door.
1.
CAUTION—HOT SURFACE:
The inside of the printer might be hot. To reduce the risk of injury from a hot component,
allow the surface to cool before touching.
Open the lower front door.
2.
Note: To avoid overexposing the photoconductor units, do not leave the front door open longer than
10 minutes.
Pull the paper forward if it is lodged under the photoconductor units.
3.
Note: You may need to remove the photoconductor units if the paper is lodged too tightly under them.
Remove each photoconductor unit, and then place it on a flat surface. See
4.
removal" on page 4-145.
Remove the jammed paper, and then replace each photoconductor unit.
5.
Close the lower front door.
6.
Close the upper front door.
7.
8. Touch Continue.
201 paper jam
Open the upper front door, and then open the lower front door.
1.
Warning: Potential Damage—To avoid overexposing the photoconductors, do not leave the front doors
open for more than 10 minutes.
CAUTION—HOT SURFACE:
The inside of the printer might be hot. To reduce the risk of injury from a hot component,
allow the surface to cool before touching.
Determine where the jam is located, and then remove it:
2.
If paper is visible under the fuser, then grasp it on each side and pull it.
•
7526
"Photoconductor unit
Diagnostic aids
3-61
Previous
Next
Go Back