Table of Contents
Advertisement
The default parameters assigned for each knob are as follows.
A: #10 Panpot (PAN)
B: #70 Sustain Level (STN)
C: #76 Vibrato Rate (VbR)
D: #77 Vibrato Depth (VbD)
Note:
If the selected zone is set to BOTH, changing the MIDI CC# parameters a ects both
internal and external sections. If you want di erent settings for internal and external
sections, enter the edit mode by pressing the MENU button and select internal or
external section with the ZONE SELECT button. (See page 35 for details.)
Changing MIDI CC parameter
Press and hold the ASSIGN button. ASSIGN button starts blinking and the cursor
in the display moves up to the parameter name.
1PA - N STN VbR VbD
0
Use the CONTROL KNOBS to change the parameters.
After changing the parameter, press the ASSIGN button again. The ASSIGN
button stops blinking and the cursor in the display moves down to the value.
Note:
When the selected zone is set to INT, only the following parameters can be
selected.
10
70
71
76
77
78
93
When the selected zone is set to BOTH and the internal section is selected in edit
mode, the parameters not available for INT section show as " XXX".
1015 STN VbR VbD
Ixx - x
0
0
0
Panpot
Sustain Level
Resonance
Vibrato Rate
Vibrato Depth
Vibrato Delay
Chorus Depth
0
0
0
PAN
STN
RSN
VbR
VbD
VbY
ChD
33
Advertisement
Table of Contents
