Assign; Amp Simulator Parameter; Midi Cc# (Control Change) - Kawai MP6 Owner's Manual

Stage piano

Hide thumbs Also See for MP6:

Table of Contents

5.4 ASSIGN

The ASSIGN button can be used to set the CONTROL KNOBS to send MIDI

Continuous Controller information to external MIDI devices, or to control the

MP6's Amp Simulator function.

If the Amp Simulator is turned on, pressing the ASSIGN button allows the Amp

Simulator parameters to be adjusted using the CONTROL KNOBS.

Drv Lvl

0 127

Note:

The Amp Simulator is e ective for Zone 1 only.

* Please refer to page 38 of this owner's manual for further information about

the Amp Simulator.

If the Amp Simulator is turned o , pressing the ASSIGN button allows MIDI

Continuous Controller information to be sent using the CONTROL KNOBS.

The MP6 can send any MIDI Continuous Controller information to any MIDI

Instrument or Device. This powerful feature allows for editing the sounds of an

external sound module in Real Time during performance, or for recording Real

Time performance edits to a MIDI sequencer.

Some control changes are also e ective to internal sounds.

Make sure that the ASSIGN button in the CONTROL KNOBS section is lit. If the

ASSIGN button is turned o , press it to turn it ON.

The CONTROL KNOBS are now active and assigned to the MIDI CC parameters.

Use the CONTROL KNOBS to change the MIDI continuous controller information

assigned to each knob as described below.

Each parameter of the Control Change has an adjustable range from 0 to 127.

When the selected zone is set to INT or BOTH, the display shows the parameter

names.

1PAN STN VbR3VbD

- 0

When the selected zone is set to EXT, the display shows the MIDI CC numbers.

3010 070 076 077

6 - 4

Table of Contents