Reset Settings; Job Reset - Develop ineo+ 224 Instructions For Use Manual

7

[Reset Settings]

To display: [Utility] - [Administrator Settings] - [System Settings] - [Reset Settings]
Select whether to reset the functions and settings that are currently displayed when this machine has not
been operated for a certain period of time.
Settings
[System Auto Reset]
[Auto Reset]

[Job Reset]

[Job Reset]
To display: [Utility] - [Administrator Settings] - [System Settings] - [Reset Settings] - [Job Reset]
Select whether to reset settings for the conditions that are applied when changing users or loading document
to ADF.
Settings
[When Account is changed]
[When original is set on
ADF]
[Next Job]
[Default Basic/Enlarge Dis-
play Common Setting]
7-10
Description
Select whether to reset all settings (except registered settings) when this
machine has not been operated for a certain period of time.
For details, refer to [User's Guide: Copy Operations].
Select whether to reset all settings (except registered settings) for each of
Copy, Fax/Scan, User Box functions when this machine has not been op-
erated for a certain period of time.
For details, refer to [User's Guide: Scan Operations].
Select whether to reset settings for the conditions that are applied when
changing users or loading document to ADF.
For details, refer to page 7-10.
Description
Select whether to initialize all settings (except registered settings) when the
key counter or management card is removed.
[Reset] is specified by default.
Select whether to reset all settings (except registered settings) when doc-
ument is loaded into the ADF.
[Do Not Reset] is specified by default.
Select whether to reset Staple Setting, Original Set/Bind Direction settings,
and TX Settings for each job.
• [Staple Setting]: Select whether or not to take over the settings upon
completion of a job for which Staple has been specified.
[OFF] is specified by default.
• [Original Set/Bind Direction]:Select whether or not to take over the set-
tings upon completion of a job for which Original Set and Bind Direction
have been specified.
[OFF] is specified by default.
• [Reset Data After Job]: Select whether to clear all settings or only des-
tinations when resetting for each job in Scan/Fax TX Settings. If you se-
lect [Confirm with User], a confirmation screen appears to ask whether
you want to clear settings or destinations.
[Reset All] is specified by default.
Select whether to configure the initial values for Normal and Enlarge Dis-
play mode at the same time.
If [Apply to All] is selected, [Default Enlarge Display Settings] does not ap-
pear. Initial values for each mode that are changed in [Default Copy Set-
tings] or [Default Scan/Fax Settings] are applied to both Normal and
Enlarge Display modes.
[Do not Apply] is specified by default.
ineo+ 224/284/364/454/554