Sweeping Mechanism; Sweeping Pattern - Kärcher ICC 1 S D Service Manual

ICC 1 S D
Sweeping Mechanism – Sweeping pattern
Adjusting sweeping pattern
Adjusting brush contact pressure
Checking sweeping pattern
Basic Settings and Service Procedures
Adjusting sweeping pattern
– Check tire pressure (see Specifications).
– Loosen clamp bolts (1).
– Adjust lateral inclination of side brush (2)
– Tighten clamp bolts (1).
1 Clamp bolts (2x)
2 Side brush
3 Stop screw
4 Lock nut
– Loosen lock nut (4).
– Turn stop screw (3) to adjust side brush
contact pressure on ground.
– Tighten lock nut (4).
Checking sweeping pattern
The sweeping pattern should be formed like a
moon-shaped sickle (approx. 120° to 150°).
– Raise side brushes.
– Drive sweeping machine onto flat and level
ground that is evenly covered with dust.
– Lower side brushes, and allow to run for a
few seconds.
– Raise side brushes, back up machine.
– Check sweeping pattern.
Direction of travel
33