Drive Pedal - Kärcher ICC 1 S D Service Manual

Basic Settings and Service Procedures
Hydraulic System – Drive pedal
Setting NEUTRAL position on hydraulic pump
1
2
Pedal linkage
1 Lever
2 Fork (adjuster)
3 Pedal linkage
4 Threaded rod
5 Lock nut
6 Reverse drive switch
48
5 4
3
Setting NEUTRAL on hydraulic drive pump
If the unit creeps forward or backward without
drive pedals being actuated, setting the NEUTRAL
position on the hydraulic drive pump will be
required.
– Loosen lock nut on cam bolt.
– Turn cam bolt (arrow) until unit no longer
creeps.
– Tighten lock nut on cam bolt.
Adjusting drive pedal inclination
When in rest position, the "Forward" drive pedal
must be positioned in parallel with the "Reverse"
drive pedal. The drive pedal position can be
adjusted at each linkage pivot point.
– Detach fork (2) from lever (1).
– Loosen lock nut (5).
– Turn fork (2) on the threaded rod (4) in pedal
linkage (3) clockwise or counter-clockwise
as required.
– Reattach fork (2) to lever (1).
Note:
When making adjustments, ensure that
pedal linkage travels freely and without
chafing.
ICC 1 S D