Replacing The Fuse; Check The Sweep Roller; Replace The Sweep Roller; Checking And Adjusting - Kärcher KM 85/50 W Comfort Operating Instructions Manual

Operating Instructions

Replacing the fuse

! Remove cover using a
screwdriver
! Replacing the fuse
! Replace cover
Note:
The automatic cutout must be
depressed.
(Applies only to
KM 85/50 W Comfort and
KM 85/50 W P Comfort)

Check the sweep roller

! Lock the hand brake
! Remove the swept material
container
! Remove tapes and string from
the sweep roller
! Insert the swept material
container
KM 85/50 W Comfort / KM 85/50 W Classic / KM 85/50 W P Comfort / KM 85/50 W P Classic

Replace the sweep roller

Replacement is necessary when the
main brush cannot be readjusted
any more and sweeping efficiency
obviously deteriorates due to worn
bristles.
! Release push handle lock by
turning it counterclockwise
(Applies only to
KM 85/50 W Comfort and
KM 85/50 W P Comfort)
Danger!
! Remove the debris container
prior to tilting the sweeper (see
the section on "Emptying the
debris container"). For
KM 85/50 W Comfort and
KM 85/50 W P Comfort it is
additionally necessary to release
the push handle lock!
! Tilt the machine back
! Unscrew the left and right
fastening screws
! Remove main brush downwards
! Pay attention to the position of
the bristle set when installing the
new main brush!
Note:
The bristle pile is structured to an
arrow which must point towards the
rear wheels.
! Insert new main brush and fasten
— Make sure that the position of the
rectangular clamping plate is
proper!
— It must overlap the main brush at
the top and bottom
! Insert the swept material
container
English

Checking and adjusting

sweeping area of the
sweeping roller
! Cover a level surface evenly with
dust
! Raise the sweeping machine on
the front and put it on the
prepared surface
! Lock the hand brake
! Run the main brush for
approx. 15-30 s
! Raise the sweeping machine on
the front and move it to the side
The form of the sweeping pattern
forms a regular rectangle, that is
between 30 - 40 mm wide.
Note:
If the sweeping pattern is uneven it
can be corrected by readjusting the
sweeping pattern width!
28