Basic Settings and Service Procedures
Hydraulic System – Pumps
Removing hydraulic pumps
Installing hydraulic pumps
1
Mounting bolts
2
Hydraulic pumps
3
Battery
4
Connecting sleeve, engine/hydraulic pump
5
Alternator
52
Removing hydraulic pumps
The hydraulic pumps powering the working
hydraulics and steering are mounted beneath the
battery (3) as an extension of the engine drive
shaft.
–
Drain hydraulic fluid into clean container.
–
Remove all hydraulic lines from pumps (2).
–
Remove a total of six mounting bolts (1).
–
Pull pumps off toward the rear.
Installing hydraulic pumps
–
Install pumps, complete with connecting
sleeve (4), engine drive shaft.
–
Install, then tighten, a total of six mounting
bolts (1).
–
Connect all hydraulic lines.
Note:
When mounting bolts have been thightened,
connecting sleeve (4) must still have free axial
travel.
Binding connecting sleeves may cause
damage to hydraulic pump bearings and to
engine.
ICC 1 S D