Connecting A M40 Board And A Lp40 Board; Figure 3.13 Connecting The Mp40/Lp40 Board; Figure 3.14 Extension Cable - Samsung OfficeServ 7400 Installation Manual

CHAPTER 3. Ошибка! Стиль не определен.
4) With the other cable, connect the 'LINK23' port of the MP40 board and the'LINK3'
port of the LP40 board.
LP40
LINK1
LINK2
LINK31 LINK32
MP40
5) For two expansion cabinets, connect the 'LINK31', 'LINK32' and 'LINK33' port of
the MP40 board built in the basic cabinet with extension cables in the same way as
described above.

3.2.5 Connecting a M40 Board and a LP40 Board

With the OfficeServ 7400 system as the basic cabinet, the expansion cabinets of the
existing OfficeServ 7200 system can be connected to the OfficeServ 7400 system. To do so,
the MP40 board and LCP board should be connected with an extension cable to enable
signal transfer between control boards.
1) Three extension cables are needed to connect the MP40 board to the LCP board.
If two expansion cabinets exist, six cables are required.
3-10
LINK3
MISC1
PSC
MISC2
LINK23

Figure 3.13 Connecting the MP40/LP40 Board

Figure 3.14 Extension Cable

© SAMSUNG Electronics Co., Ltd.