Filter Change - WMF 1300 Series User Manual

Descaling
Insert the water tank filled with descaling solution, and
™
confirm on the display
Descaling begins. This part of the routine takes about
13 min.
Remove water tank and empty out remaining descaling
™
solution
™ Rinse water tank and fill to maximum with cold water
Replace the water tank
™
rinsing
Rinsing begins. After the initial rinse from the water tank,
the display requests that the water supply be turned on
again. This part of the routine takes about 22 min.
Turn on mains water tap
™
Leave the water tank in place. The water tank connector
is rinsed for approximately 10 seconds from the mains
supply.
Remove water tank and dry
™
Turn and remove seal plug on water tank connector
™
in a clockwise direction
(flat screwdriver, see illustration 1 and 2)
Replace the water tank
™
Subsequent rinses are from the mains supply.
After the final rinse the steam boiler is heated. The hot
water expands and finally exits briefly as steam.
The descaling is complete. Completion is indicated on the
display.

Filter change

If the filter capacity is exceeded, there will be a message
once per day that a filter change is due.
The filter must be changed within one week; otherwise, the
message will be displayed after every brew.
Change filter
™
Confirm filter change
™
After filter change there is an automatic program
sequence to rinse and bleed the anti-scale filter and water
system. Hot water runs out of the hot water spout during
this process.
User Manual WMF 1300
Software
Illustration 1
Illustration 2
CaUtioN
Burn hazard.
Scald hazard.
Hot steam.
Don't reach under
the dispensing area.
See chapter 9.1:
Safety.
filter change
Observe water filter instruction.
Displays lead step by step through
the program.
Follow the instructions.
CaUtioN
Scald hazard.
Don't reach under
the dispensing area.
29