Table of Contents
Advertisement
1.8.6
COM3/7 RS 232/422/485 mode selector (JSETCOM3456/78910)
Users can use JSETCOM3456/78910 to select among RS 232/422/485 modes for
COM3 and COM7. The default setting is RS 232.
Table 1.5: COM3456/78910 RS 232/422/485 mode selector
(JSETCOM3456/78910)
Function
*RS232
RS422
RS-485
*: Default
1.8.7
LVDS Power Jumper Connector(JLVDSPWR1)
JLVDSPWR1 is the jumper for either 3.3 V or 5 V output when connector to LCD
panel.
Table 1.6: LVDS power jumper selectior
Function
connect to 3.3 V
connect to 5 V
1.9
System Memory
The AIMB-562 KIOSK has two sockets for 240-pin SODIMMx2.
All these sockets use 1.8 V unbuffered double data rate synchronous DRAMs (DDR2
SDRAM). They are available in capacities of 512 and 1024 MB. The sockets can be
filled in any combination with DIMMs of any size, giving a total memory size between
512 MB and 2 GB. AIMB-562 KIOSK does NOT support ECC (error checking and
correction).
1.10
Memory Installation Procedures
To install SODIMMs, first make sure the two handles of the SODIMM socket are in
the "open" position. i.e. The handles lean outward. Slowly slide the SODIMM module
along the plastic guides on both ends of the socket. Then press the SODIMM module
right down into the socket, until you hear a click. This is when the two handles have
RS232
RS422
Jumper Setting
(5-6) + (7-9) + (8-10) + (13-15) + (14-16) closed
(3-4) + (9-11) + (10-12) + (15-17) + (16-18) closed
(1-2) + (9-11) + (10-12) + (15-17) + (16-18) closed
Jumper Setting
1-2 pin closed
2-3 pin closed
9
RS485
AIMB-562 KIOSK User Manual
Advertisement
Table of Contents
