Cancel An Incomplete Marking Operation; Replay An Event; Cancel Incomplete Marking Operation - NewTek 3play User Manual

7.3.1.1 ONE-BUTTON METHOD
With 3P in LIVE mode, watch for notable events on the Main Output monitor, and press MARK
LAY
OUT whenever one occurs.
This creates a new event, sets an Out Point at the current timecode, and sets the In Point
automatically to establish a default Duration (see Sections 5.5.1 and ). You can later trim the event
if you wish.
7.3.1.2 TWO-BUTTON METHOD
1. With 3P in LIVE mode, press MARK IN at any convenient time. This creates a new
LAY
'incomplete' event in the Master List.
2. Press MARK OUT when you observe something interesting occur on Main Output. This
completes the event – see Section 5.5.2.
Hint: Many other useful details with respect to marking can be found in Sections 3.2, 5.5, and 6.2.2.

7.3.2 CANCEL AN INCOMPLETE MARKING OPERATION ?

1. Press ESC on the 3P-10 control surface (or Esc on the keyboard) – see Section 6.2.2.

7.3.3 REPLAY AN EVENT?

1. Use the 3P-10 control surface TAB and Arrow buttons to choose an event, then press ALT
+ Play, or ...
2. Use the 3P-10 control surface to type the ID# for an event, press Enter to confirm the
entry, and then press ALT + Play (see Sections 6.2.10 and 6.2.8), or ...
3. Double-click an entry in the Event Panel.
RELATED QUESTIONS:

I pressed Play, so why is my output frozen?
o
Check to see if your Speed-Bar is set at the 0% position.
Page 89