Connect The 3P-10 Control Surface; Connect The Genlock Reference Signal; Connect An External Hard Drive; Connect The External Control Surface - NewTek 3play User Manual

For 3-Out output mode, you will need three such connections to view all of 3P
For 1-Out output mode, all three of 3P
by the 3P operator (see Sections 3.4.2 and 6.3.1.1).
LAY
1. For downstream video monitoring, connect cables between your downstream devices
(whether monitors or a broadcast switcher) and the appropriate output connectors on
3P 's front panel (see Section 4.4.2).
LAY
2. Open a 3P
LAY
panel by clicking the small 'gear' icon at upper-right in the titlebar of the 3P
3. Set the Output>Video Connection type (see Section 4.4.3) to suit the connected external
monitor(s).
RELATED QUESTIONS:

I connected video sources and monitors, but don't see video being passed through 3P
– why not?
Source video streams are not sent to 3P
Section 3.2).

7.1.3 CONNECT THE 3P-10 CONTROL SURFACE?

Connect the USB cable from the 3P-10 Control Surface to one of 3P

7.1.4 CONNECT THE GENLOCK REFERENCE SIGNAL?

1. Connect the reference signal to the Genlock Input on 3P
2. See Section 4.4.4 for details on configuring Genlock settings.

7.1.5 CONNECT AN EXTERNAL HARD DRIVE?

Connect an external hard drive to one of 3P
probably be formatted using the NTSF file system (the FAT file system chokes on exported files
exceeding 4 Gigabytes, as will often be the case).
's output connections transmit the same stream, selected
LAY
session from the Administration Screen, and access the I/O Configuration
s outputs unless Record is enabled (please see
LAY
's USB 2.0 ports. Note that the external drive should
LAY
Page 85
's output streams.
LAY
LAY
's USB 2.0 ports.
LAY
's faceplate.
LAY
Desktop.
LAY