Installing Single Line Adapters (Sla); Wall-Mounting An Sla - Mitel Inter-Tel 5000 Installation And Maintenance Manual

Chapter 5: Installation

Installing Single Line Adapters (SLA)

Installing Single Line Adapters (SLA)
When installed in a DEM-16 port, each SLA unit can support one DID [DDI] trunk, two single
line endpoints, or one off-premises extension (OPX).

Wall-Mounting an SLA

The SLA can be placed horizontally on a table, or it can be wall-mounted using the two L-
shaped brackets that accompany the unit.
To wall-mount an SLA unit:
1.
2.
3.
4.
Setting Hybrid Balance Straps for a DID [DDI] Trunk on an SLA
SLAs are shipped with both ports set for single line device operation.
To change the port type if connecting a DID (DDI) trunk:
1.
2.
3.
Page 5-132
Remove the two screws on one side of the unit
and use them to attach the two L-shaped wall-
mounting brackets. See the figure at right.
Position the SLA on the MDF backboard and mark
the location of the mounting screw holes on the
wall. Set the SLA aside.
Drive a screw into the center of each mounting
hole marking, allowing the heads of the screws to
protrude slightly. Use screws of sufficient strength
to support the SLA.
Hang the SLA on the screws. If necessary, adjust
the screws to ensure the SLA is held firmly in
place.
Remove the cover and set the corresponding port for DID (DDI) operation.
PORT 1 (J3)
SL
If necessary, adjust the hybrid balance setting from short (<.6 mi, or 1km) to long (>.6 mi,
or 1km).
PORT 1 (J2)
LG
Replace the cover.
PORT 2 (J6)
DID/DDI DID/DDI
SL
PORT 2 (J5)
SHT LG SHT
®
Inter-Tel 5000 Installation Manual – Issue 2.4, May 2008