Installing The Processing Server (Ps-1) - Mitel Inter-Tel 5000 Installation And Maintenance Manual

Figure 5-27
Figure 5-27.
DB-15
Monitor
VGA
(not included)
Connection
to monitor
Mouse
(optional)
Keyboard
Monitor
power cord

Installing the Processing Server (PS-1)

To see the location of connectors on the PS-1, see Figure 5-26 on
To install a PS-1:
1.
2.
3.
4.
5.
6.
7.
®
Inter-Tel 5000 Installation Manual – Issue 2.4, May 2008
shows the back of PS-1 units.
Processing Server (PS-1) Chassis, Back View
USB Security Key
(Insert in any
USB port.)
or
Null modem
with Hardware Flow Control (Part no. 804.2605)
RS-232 cable
DB9M to DB9F Straight-through
(Part no. 813.1683)
Isolated, dedicated, single-phase commercial power source
Rack mount the PS-1 (recommended).
Make sure the power switches on the front and back of the PS-1 are turned off. See
Figures 5-26 and Figure 5-27 on
Connect the PS-1 to an AC power source, but do not turn either of the power switches
on at this time. For electrical requirements, see Table 4-13 on
Using a CAT5 or CAT5e cable terminated on both ends with RJ-45 plugs, connect the
PS-1 to the network through the same 100 Mbps LAN switch as the Base Server.
The PS-1 and Base Server must be connected to the network on the
IMPORTANT same LAN, VLAN, and subnet. For additional details, see "Network
Environment Requirements" on
Connect a monitor and keyboard to the PS-1. See
keyboard are not available, you can use a laptop PC equipped with a DB-9 serial port. In
the alternate mode using a laptop PC, connect the PS-1 to the laptop with a straight-
through RS-232 cable and null modem with hardware flow control, as shown in
27.
Turn power on using the On/Off switch on the back of the chassis. Leave the On/Off
switch on the back of the chassis turned on at all times.
Turn power on using the button switch on the front of the chassis. Use the button switch
to control power to the system. Leave the On/Off switch on the back of the chassis
turned on at all times.

Installing the Processing Server (PS-1)

RJ-45 to LAN
USB ports
Connect to Laptop PC
page 5-53.
page 5-146.
Figure
Chapter 5: Installation
Power
On/Off
Switch
Fan
PS-1
power cord
page 5-52 and Figure 5-27.
page 4-31.
5-27. If a monitor and
Figure 5-
Page 5-53