Table of Contents
Advertisement
6.2.4 Analog Video Output and Serial Interface (default configuration)
The default video output is the analog output and is labeled as "Video Output" on the group interface
back panel (see Figure 7: Group Interface Back Panel View). The video output is NTSC and PAL
(future) and the connector is a Samtec MCX7-J-P-H-ST-TH1. When using the video output, camera
control and status uses the USB or RS232 (future) serial interface connector, labeled "USB" and "RS232"
on the group interface back panel.
The USB interface is the industry standard mini-USB with the connections as shown in Table 7
Note: the camera is NOT powered through the USB connector.
6.2.5 Trigger In/Out
The Trigger IO connector is a Hirose SR38-4R-3S(71) and is labeled "TRIG IN/OUT on the rear of the
camera.
10-10032-01
Rev A1
Table 7: USB Mini-B Interface
Pin #
Function
1
VCC
2
D-
3
D+
4
ID
5
GND
Table 8: TRIG IN/OUT Interface
Pin #
Function
1
TRIGGER IN
2
TRIGGER OUT
3
GND
2011 FLIR Advanced Imaging Systems
Tau CNV Camera User's Manual
Description
+5VDC
Data -
Data +
A/B Distinction
Signal Ground
Description
Logic Level
Logic Level
Signal Ground
ECO: 594
page 25 of 49
Advertisement
Table of Contents
