Lan Connection; Power Connection - Barco ClickShare Installation Manual

4. ClickShare installation
4.6

LAN connection

About LAN connection
The Base Unit can be connected to a local network or directly to a laptop. For normal operation, a LAN connection is not necessary.
The LAN connection can be used:
• to configure your ClickShare unit
• to update the software
• for maintenance purposes
• to power your ClickShare via Power on Ethernet, if your LAN network supports that function.
How to connect
1. Insert a network cable with RJ-45 connector into the LAN port.
2. Connect the other side to a LAN.
4.7

Power connection

About power
The Base unit can be powered in two ways
• Via Ethernet when the LAN network supports Power on Ethernet.
• Via an external power adapter.
Once the Base unit is powered, it starts up. Then the power button can be used to switch on or off.
How to connect the external power adapter.
1. Plug the barrel connector of the power adapter into the power input of the Base unit.
2. Slide a power input adaptor piece (US, CN, EU or UK) on the power adapter of the ClickShare Link . Use the one which is
applicable in your country.
Image 4-4
Type A
3. Connect the power cable to the wall outlet.
20
Image 4-5 Image 4-6
Type C Type G
Image 4-7
Type I
R5900014 CLICKSHARE 16/09/2013