Operation - RTS BP-325 User Manual

CONNECTIONS AND OPERATION
Channel 1 talk button, indicator light and listen
1.
volume control.
2. Channel 2 talk button, indicator light and listen
volume control.
3. Call button and indicator light.
Carbon-mic headset jack. May also be used
4.
for external mic switch. See "Programable Options".
5. Program volume control. Active only when using the
line loop connector for optional program input.
See "Programable Options".
6. Monaural dynamic-mic headset jack.
Intercom line loop connector for connection to
7.
additional intercom stations. May also be used for
external program input, external mic switch, or a
non-standard power source. See "Programable Options"
and "Alternate Powering Methods".
8. Intercom line connector. For connection to intercom
system.
9. Stereo dynamic-mic headset jack.
Rear cover removal to set options:
10.
Loosen two screws (10a) and remove
one screw (10b).

OPERATION

Attach the BP325 to your belt or other convenient location using the belt clip on the rear panel.
1.
Put on the headset and adjust the listen volume controls while listening to the intercom channels.
2.
A TALK button may be activated in either of two ways:
3.
Momentary Mode: Press and hold the TALK button, then speak into the microphone. The green talk
LED will remain lit while the TALK button is held. Release the TALK button when finished talking.
The talk LED will turn off.
Latching Mode for Hands-free Conversation: Tap the TALK button (do not press and hold). The
green talk LED will turn on and remain on. When finished talking, tap the TALK button again. The
talk LED will turn off.
Calling an intercom channel:
4.
a.Turn on the TALK button for the channel to be called (the green talk LED should be lit).
b.Press and hold the CALL button. The red call LED will light while the button is pressed, indicating
that a call signal is being sent. When a response is heard, release the CALL button and begin your
conversation.
c.Turn off the TALK button when finished with your conversation.
Receiving a call:
5.
2
1 2
A L A
T K T
4
MONO LINE LOOP CARB-MIC LINE
HEADSET AUX I/O HEADSET INPUT
10a
REMOVE
COVER
6 7 10b
L
K
C A L L
3
5
PGM STEREO
VOL HEADSET
10a
8 9