Page 1
USER MANUAL MODEL BP317 Portable Belt Pack User Station RTS '" Rev D l 9350-5435-00 1/95...
Page 2
Manual. defective improper associated equipment, alt&npts and repair not authorized by Telex, and s h ~ ping damage. Roducu wlth theu serial numbers remov e i or effaced are not covered by this warranty. To obtain warranty service, follow the procedures entitled "Rocedure For R ~ u m s "...
Page 4
"microphone" using type cable. The BP317 contains two conmls to help the user ininterface well to the i n m m system: the volume control, and the microphone s w i t c h .
BP317 SPECIFICATIONS Input DC Voltage 18 to 35 volts (12 to 17 volts, reduced DC C m n t ' 2 0 milliamperes Quiescent Operating, 10 dB below dipping 25 headphones 35 milliamperes Impedance L i e Across 10,000 ohms, minimum...
This diagram will be used to update the original documentalion. and for Power), each cable. (1) One type of mounting for the BP317 is patable, when it is worn on dothing has a be ope@ed from (2) Another type of mounting for the BP317 is permanent semi-permanent, either a "desk mount"...
DT109 DT108 headwi Low im- the DTlO8 and DTlW headsets, cause the BP317 to require mwe powex fmn the power supply. With DT109 headsets, BF' 3 17 peak current is 75 milhamperes. With 600 headphones.BP317 peak current is 30 milliamperes.
See Section 5 for inshudions An insrallaton drawing f a headset user station BP317 is included at the end of this section. These drawings provide m e c h a n i c a l information useful forpermanent and other type installations.
SECTION OPERATION 3.1 Operating Controls And Connectio11~ Table 3-1 below lists the Model BP.17 to the circled numbers in Figure 3-1. Ref. & & I . & Front Panel VOLUME control MIC ON toggle Rear Panel DYNAMIC micro~hone INTERCOM INPUT ("line") conneetor Operation 3 .