Gobo Set Zero Position - PRG bad boy User Manual

B B ™ S L
AD OY POT UMINAIRE

Gobo Set Zero Position

The Gobo Set Zero command allows adjustment of the gobo wheel's home position. When this
command is issued, the luminaire sets the current wheel position as the "zero" position and stores this
offset so it will be retained at the next startup. This allows correction for a sensor that may be slightly
out of position causing the gobo wheel to not be perfectly centered and therefore obstructing part of the
beam in the open position.
To set zero position:
Step 1. Using console, move wheel into desired center position.
Step 2. Execute Set Zero Position command (Control Channel DMX value 80). The luminaire will
now remember the setting as the new zero position.
3 6
U M
SER ANUAL
OPEN BEAM
OUT OF ALIGNMENT
Figure 3-4: Gobo Alignment
GOBO WHEEL #2
GOBO WHEEL #1
PROPERLY ALIGNED
02.9812.0001A