Installation Procedure; Installing Luminaire In A Hanging Configuration - PRG bad boy User Manual

Hide thumbs Also See for bad boy:
Table of Contents

Advertisement

Installation Procedure

Installing Luminaire in a Hanging Configuration

The Bad Boy™ Spot Luminaire can be hung horizontally or vertically from any structure designed to
accommodate the load of this moving luminaire. Two provided Hanging Bracket Assemblies
(21.9812.0863) are used to attach the luminaire to a truss pipe. The Hanging Brackets consist of a pre-
assembled bracket with a Mega-Claw Truss Hook.
To unpack and attach brackets:
Step 1. Unlatch and remove case lid (Figure 2-2).
Step 2. Remove Power Cord, Safety Cables, and Hanging Brackets from case.
Step 3. Tilt luminaire enclosure upright as shown.
Step 4. Install Hanging Brackets as follows:
a. Choose orientation. Brackets may be attached in one of four positions. Refer to Figure
b. Orient Hanging Bracket in desired direction over two attachment buttons on bottom of
c. Place Hanging Bracket down over buttons and slide until bracket locks into place (you
Case
0 2. 9 8 1 2. 0 0 01 A
2-3 for a diagram of the orientation options.
upper enclosure (Figure 2-2).
will hear a "click" when bracket is locked).
Safety Cable (2)
Figure 2-2: Opening Case and Attaching Hanging Brackets
I
NSTALLATION
Power Cord
: I
P
NSTALLATION
ROCEDURE
Hanging Bracket (2)
2
11

Advertisement

Table of Contents
loading

Table of Contents