Dmx512 Male Termination Connector; Ethernet Cables - PRG bad boy User Manual

B B ™ S L
AD OY POT UMINAIRE

DMX512 Male Termination Connector

A male XLR DMX512 termination connector is required at the last
luminaire (or "far end of the line") to prevent signal reflections. Signal
reflections may cancel out the signal at certain line lengths, resulting in
errors. The terminator is also necessary for software downloads and
running tests on multiple luminaires. To construct your own connector,
you will need the following components:
• 5-pin, male XLR connector.
• Two 1/4W 5% 120 ohm resistors.
Note: A male termination connector is also available as an accessory from PRG. See
Items and Accessories" on page

Ethernet Cables

The Bad Boy Luminaire is equipped with two RJ-45 type connectors for Ethernet input/output.
Ethernet cabling should follow these guidelines:
• Ethernet cable assemblies must match the CAT5e specification.
• Regular or crossover cables are acceptable.
• Both EtherCon® and RJ-45 connectors are acceptable.
1 0
U M
SER ANUAL
5.
1 5
2 4
3
Solder resistors across
pins 2 & 3, and 4 & 5
"Replacement
02.9812.0001A