Table of Contents
Advertisement
2
I
: P
U
P
NSTALLATION
OWER
P
ROCEDURE
Programming a Starting Address
The address setting for DMX512 systems is programmed at the Menu Touchscreen (refer to
"Menu
System" on page 22
for more detailed instructions). The luminaire retains its DMX512 address even if
power is removed.
Note: Refer to your console operating instructions for specific information regarding its addressing
requirements.
To program a DMX512 starting address:
Step 1. At Home screen, press CONFIG panel.
Step 2. At Configuration screen, press DMX ADDRESS panel.
Figure 2-10: Setting DMX512 Address
Step 3. At numeric keypad, enter new DMX512 starting address and press ENTER.
Note: Refer to
"Menu System" on page 22
for more information about the Menu Touchscreen.
19
0 2. 9 8 1 2. 0 0 01 A
Advertisement
Table of Contents
Troubleshooting
