Power Up Procedure; Powering Up The Luminaire - PRG bad boy User Manual

Power Up Procedure

Powering Up the Luminaire

When AC power is applied, the luminaire will begin a calibration sequence which moves its pan, tilt,
and all beam control mechanisms. After calibration, the luminaire head will either stop at its "home"
position (which positions the pan axis at mid-rotation and the head parallel to the yoke with the lens
pointing away from the luminaire upper enclosure) or move to its current DMX-defined position if
DMX512 data is present. The beam control mechanisms will also move to their "home" or DMX-
defined positions. The lamp is set to OFF in the default mode.
The luminaire also contains an on-board battery so that it can be addressed and configured without
being connected to main power. (To bypass calibration, refer to
CAUTION: Before applying power, be sure the luminaire is hung or positioned so that the head and
yoke can move freely without restriction. Refer clearances in Figure 2-5 on
CAUTION: If luminaire is operated without yoke leg covers in place, pan problems will occur.
To power up:
Step 1. At each luminaire, connect power. Allow luminaire to complete its calibration sequence.
Step 2. For normal power up, the Menu Touchscreen "Home" screen will display Status OK. The
Home screen will also display the luminaire's DMX address and lamp information.
Step 3. Check Comm LED for proper operation. Refer to
Step 4. To strike lamp, send appropriate command from console or follow steps provided in
"Starting the Lamp" on page
Home Screen
Note: Refer to
0 2. 9 8 1 2. 0 0 01 A
20.
Figure 2-9: Menu Touchscreen at Power Up
"Menu System" on page 22
I
NSTALLATION
"Bypassing Calibration" on page
"Comm LED Operation" on page
COM M
for more information about the Menu Touchscreen.
: P U P
OWER P ROCEDURE
page 13.
18.
AC IN
200 -240 VAC
T HRU
DMX ET HERN ET
50 /60 Hz
IN 15A M ax
2
18.)
17