Symptoms & Solutions When Using The Bryce Feeder - Bryce 30K User Manual

Symptoms and Solutions when using the Bryce Feeder
SYMPTOM
Transport Belt turning,
Feed Rollers won't turn.
(Paper Out Error)
Early Feed Error
(Error Message)
Stream Feeding of the
media
(Early Error Message)
Feeder is not sending
media consistently.
(Intermittent feed problem)
Revision C
CAUSE
Feeder connector is loose.
Loose set screw on pulley
or gears not engaging.
Bad Feeder Motor or
Loose pulley.
Faulty or dirty sensors
Thickness of Separator "H"
Block is set to high
Feed Gap is too short for
the media.
Faulty or dirty sensor.
Feed Roller is not stopping.
Thickness adjustment set
incorrectly
Stack of media is too
small.
Feed Rollers glazed or
contaminated with paper
dust.
Feed Ramp Assembly and
Media Support Wedge is
positioned or being used
incorrectly.
Feed Rollers worn down
30K USERS MANUAL
P/N 90-00203-001
Troubleshooting and Diagnostics
SOLUTION
Disconnect Feeder and reattach to Printer.
Call Service Representative
Call Service Representative
Clean sensors with canned air or soft cotton cloth.
Call Service Representative.
Reset the height of the Separator "H" Block.
Increase the setting in the Feed Gap menu
Clean sensors with canned air or soft cotton cloth.
Call Service Representative.
Adjust the Separator "H" Block according to
users manual.
Place a larger stack of media on Feed Rollers.
Clean with water and plastic scouring pad.
Reposition Feed Ramp Assembly and Media
Support Wedge to transfer the weight of media
onto Feed Rollers.
Replace Front or Rear Feed Rollers.
Section 7 - 7