Bryce 30K User Manual page 72

6. Using a regular screwdriver, release the four 1/4 Turn
Studs on the Floor. Turn each stud counterclockwise a
quarter turn. Note: The four 1/4 Turn Studs are
permanently attached and cannot be removed.
7. Lift the Floor. Unhook the front of the floor and slide
it beneath the Sliding Fences.
8. Reference figure to right. Located inside is the Feed
Roller Assembly. From the side of the assembly,
release the Extension Spring from the Belt Tensioner
Lever.
9. Remove the 3 mm Belt from around the two Feed
Pulleys. Note: The Feeder Assembly with two Idler
Pulleys located in the center uses the Old Style belt.
10. Pull the Upper or Lower Feed Roller Shaft Assembly
from the printer. A bearing will come out with the
feeder shaft assemblies. Remove these parts from the
printer.
11. The Tires may now be removed by pulling them from
the hubs.
12. Replace in reverse order.
Revision C
Cleaning and Maintaining the Printer
30K USERS MANUAL
P/N 90-00203-001
Slide Floor beneath Sliding
Fences.
Release Extension Spring.
Walk belt off Feed Pulleys
Pull the Tires off the hubs.
(Old Style Belt)
Pull the Tires off the hubs.
4
Section 8 -