Cleaning The Wipers; Cleaning The Transport Belts And Floor Assembly - Bryce 30K User Manual

The Wipers beneath the banks of Print Head Assemblies will
over time pick up ink,
wax, clay and other
material from the media it
touches. Once enough wax
or clay, etc, accumulates
on the wipers it will leave
marks or smears on the
media. Use water to
dampen a soft cloth to
remove any ink, wax, clay,
etc. and keep the wipers
clean.
When the Exit Idler
Roller is adjusted over
the area where
addresses are printed
the ink will get
transferred from the
media onto the roller.
Use water to dampen a
soft cotton cloth to
remove the ink from the
rollers.
Ink will get sprayed on the Transport Belts and the Floor
Assembly from all the purging, setting up and printing
records, etc. Eventually an adequate amount of ink will
accumulate on top of the Transport Belts to give the belts a
glossy sheen. Use water to dampen a soft cotton cloth to
remove the ink from
the Transport Belts
and the Floor
Assembly. Raise the
Print Head
Assemblies up and
out of the way to
clean the Floor
Assembly.
Revision C
Cleaning and Maintaining the Printer
Side View
30K USERS MANUAL
P/N 90-00203-001
Bottom View
Cleaning
the Wipers
Cleaning
the Exit
Idler Roller
& Entry
Rollers
Cleaning
the
Transport
Belts and
Floor
Assembly
2
Section 8 -