Team Losi XXX-S Graphite Owner's Manual page 32

Step H-8
Reciever/Antenna Install
q
1. Cut a piece of Two-Sided Tape (135) to the same size as the
bottom of the receiver (not included). Peel one side of the backing
off and stick the Tape to the bottom of the receiver.
q
2. Make sure that the area on the Chassis (27), between the motor
and the servo, is clean. Wipe this area off with a clean cloth or rag.
Rubbing alcohol can be used to clean any oily residue that
may be present on the Chassis or receiver. Allow the alcohol to dry
before applying the Two-Sided Tape.
q
3. Peel the backing off the the Two-Sided Tape and install the
receiver to the left side of the Chassis, between the motor and servo,
with the antenna wire exiting the receiver towards the center of the
car as shown in Figure 65.
q
4. Run the antenna wire from the receiver, through the small hole
in the Antenna Mount (134). Press the Antenna Mount into the hole
in the top of the center rib in the Chassis. Slide the antenna wire
through the Antenna Tube (140) so that the wire comes out the other
end of the Tube.
If antenna wire is shorter than the tube, remove the Tube and
cut off enough of the Tube so that the wire will extend about 3/4"
past the end of the Tube. DO NOT cut off any excess antenna wire.
Doing so may cause you car to "glitch".
q
5. While pulling the wire through the Antenna Tube, slide the
Antenna Tube down and push it firmly into the Antenna Mount on
the main Chassis.
q
6. Fold the wire down over the Antenna Tube and place the
Antenna Cap (141) over the Tube, and excess wire (Figure 65).
q
7. Locate the receiver wire on your ESC. Place the wire into the
channel on the left side of the Chassis. Hold the wire in the channel
by placing a #4 x 0.030 Washer over two 4-40 x 1/4" Button Head
Screws (38) and threading them into the two holes in the Chassis
Step H-9
Gear Cover Install
q
1. Locate the Gear Cover (138) and cut the bottom side of it along
the trim line as shown in gray in Figure 66B. Drill three 1/8" mounting
holes in the gear cover at the three locations marked with dimples.
q
2. Place the trimmed Gear Cover over the Spur Gear (36) and
secure it with three 4-40 x 1/8" Button Head Screws (139) through the
three open holes in the top of the Chassis (27).
You may opt. to run the ESC wires through the gear cover with
the small cut-out on the bottom of the Gear Cover shown in Figure
66A. If you will be running the wires over the gear cover you should
leave that material there.
BAG H (Continued)
139
38
37
Figure 65
140
134
Figure 66A
138
29
141
27
37
Figure 66B
139
27
38