Bag F - Team Losi XXX-S Graphite Owner's Manual

Step F-1
Shock Cartridge Assembly
105
q
1. Place one Shock O-ring (105) into the Cartridge Body (104),
making sure that the O-ring sits flat in the bottom of the Cartridge
Body.
q
2. Insert the Cartridge Spacer (106) into the Cartridge Body fol-
lowed by a second O-ring.
q
3. Once the second O-ring is inserted, and is flush with the top of
the Cartridge Body, press the Cartridge Cap (107) onto the Cartridge
Body until it snaps in place.
q
4. Make four Cartridge assemblies.
Cartridges in some kits may be pre-assembled at the factory.
Step F-2
Shock Shaft Assembly
q
1. Place a drop of Shock Fluid (115) on the grooved end of each
Front Shock Shaft (156), and each Rear Shock Shaft (108). Slide a
Cartridge , hex end first, down the Shock Shaft towards the threads as
shown in Figure 51, on all four Shafts.
q
2. Using pliers or small vise grips, grasp the Shock Shaft between
the grooves and thread a Shock End (109) all the way onto the Shaft
until the threads stop.
q
3. Repeat Step 1-2 on all four Shock Shafts.
q
4. Carefully snap a 1/4" Aluminum Shock Mount Ball (110) into
each of the Shock Ends on each of the four Shock Shafts.
Step F-3
Shock Piston Install
q
1. Snap a 1/8" E-clip (112) into the groove closest to the Car-
tridge on both Front (156), and Rear Shock Shafts, (108).
q
2. Slide a "Red", #56 Shock Piston (113) onto all four shock shafts
until the Piston rests against the E-clip (112). Secure the Pistons to
the Shafts with a second E-clip.
106
108
156
110
112

BAG F

Figure 51
108
Rear
110
Figure 52
112
Rear
22
Figure 50
105
104
110
109
113
113
108
107
106
104
Small Groove in
Extra Short Shaft
Only
156
Front
156
Front