Team Losi XXX-S Graphite Owner's Manual page 27

Step F-6
Rear Shock Install
121
q
1. Position the bottom of an assembled "Long" Rear Shock in
front of the Shock mounting area on the Left Rear Suspension Arm
(92) as shown in Figure 55. Align the hole in the Shock Mount Ball
(110) with the Outside Hole in the Arm.
q
2. Attach the Shock to the Rear Arm by threading a 4-40 x 1/2"
Cap Head Screw (122) through the Shock Mount Ball into the outside
Shock mounting hole in the Suspension Arm.
q
3. Slide a "Long" Shock Mount Bushing (123), large side first,
over the Screw (66) on the left side of the Tower.
Before attaching the top of the shock, make sure that the
dogbone is in place in the outdrive.
q
4. Place the top of the Shock Body (114) over the Shock Mount
Bushing. Secure the Shock to the Tower by threading a 4-40 Nylon
Locknut onto the Shock Mount Screw.
q
5. Repeat Steps 1-4 for the Right Rear Shock assembly.
Step F-7
Front Shock Install
120
q
1. Position the bottom of an assembled "Short" Front Shock in
front of the Shock mounting area on the Left Front Suspension Arm
(63) as shown in Figure 56. Align the hole in the Shock Mount Ball
(110) with the Middle hole in the Arm.
q
2. Secure the Shock to the Arm by threading a 4-40 x 1/2" Cap
Head Screw (122) all the way into the Arm from the front.
q
3. Slide a "Short" Shock Bushing (120), large side first, over the
Screw (66) on the Left side of the Front Shock Tower.
Once again, before attaching the top of the shock, make sure
that the dogbone is in place in the outdrive.
q
4. Place the top of the Front Shock Body (157) over the Shock
Mount Bushing on the Tower. Secure the Shock assembly to the
Tower by threading a 4-40 Nylon Locknut (121) onto the Shock Mount
Screw.
q
5. Repeat Steps 1-4 for the right shock assembly.
BAG F (Continued)
123
122
122
121
Figure 55
66
123
121
114
110
122
66
120
157
121
122
24
92
63
110
Figure 56