Team Losi XXX-S Graphite Owner's Manual page 13

WIDE
NARROW
Figure 22
Step C-5
Servo Mount Install
37
q
1. Use Figure 22 to determine how the Servo Mounting Posts
(55), (56) should be attached to the servo (not included) in the Wide
or Narrow position.
q
2. Place a #4 Hardened Washer (37) over each of the four 4-40 x
3/8" Button Head Screws (49) and attach the Servo Mounting Posts
to the servo by threading the Screws through the servo mounting
ears into the Upper and Lower holes in each Post. Do not tighten the
screws yet! Just snug them up so that the posts are held in place, but
can still be moved from side to side with a little resistance.
q
3. As shown in Figure 23, you will use the Chassis to determine
the exact spacing needed for your brand servo. With the Screws still
loose, push the Pins on the Servo Mounts into the holes in the bot-
tom of the Chassis (27). Slide the mounts until the Screws are cen-
tered on the servo, and tighten as indicated in Figure 23.
The servo should be as close to centered between the two Posts
as possible.
BAG C (Continued)
S131, S131SH, S148, 23001, S3003, 25101, S9101,
S9201, S9304, S9401, S9403
S3401, S9402, S9404, S9450
NES-507, NES-513, NES-517, NES-901, NES-4000,
NES-4131, NES-4721, NES-4735, NES-9021, DS-
PS-702, PS-703, PS-1001, PS-1003
49
SERVO TYPE
AIRTRONICS
ALL
FUTABA
FUTABA
HiTech
ALL
JR
JR
Z4750, Z8450
KO
KO
PS-901BH, PS-902
MULTIPLEX
ALL
Table 22
Figure 23
56
27
10
REQUIRED
OFFSET
SERVO ARM
NARROW 23
WIDE 25
NARROW 25
NARROW 24
NARROW 23
WIDE 23
WIDE 23
NARROW 23
NARROW 23
55
37
49