Team Losi XXX-S Graphite Owner's Manual page 8

Step B-3
Front Diff Install
20
q
1. Slide one 1/2" x 3/4" Bearing (20) over each of the Outdrive
Cups (7),(15).
The Diff adjustment Screw should be facing the drivers left side
of the Chassis.
q
2. Pull the Belt (26) slightly out of the front of the Chassis (27)
and install a Diff assembly into the slots as indicated in Figure 12. Pull
the slack from the Belt through the rear of the Chassis.
q
3. Secure the Diff assembly by installing the Front Diff Cover (29)
with two 4-40 x 1/2" Cap Head Screws (122) through the Diff Cover
into the two holes in the Chassis.
q
4. Flip the Chassis over and install the two 4-40 x 3/8" Flat Head
Screws (31) through the bottom of the Chassis into the Front Diff
Cover as indicated in Figure 12.
There is a short thread-cutting screw included in the wrench
bag. This screw can be used to tap threads in the holes in the main
Chassis and the bottom of the Diff Cover. Pre-tapping these holes
makes it easier to install the Screws during assembly.
Step B-4
Rear Diff Install
20
q
1. Slide one 1/2" x 3/4" Bearing (20) over each of the Outdrive
Cups (7),(15) on the remaining Differential.
Once again, the Diff Adjustment Screw should be facing the
drivers left side of the Chassis.
q
2. Spread the Belt (26) apart and install the Diff assembly into the
slots of the Chassis (27) as indicated in Figure 13. Once the Diff
assembly is in place, pull the slack up through the center of the Chas-
sis from the top side.
q
3. Secure the Diff assembly by installing the Rear Diff Cover (32)
with two 4-40 x 1/2" Cap Head Screws (122) through the Diff Cover
into the holes in the rear of the Chassis.
q
4. Flip the Chassis over and install the two 4-40 x 3/8" Flat Head
Screws (31) through the bottom of the Chassis into the Rear Diff
Cover as indicated in Figure 13.
There is a short thread-cutting screw included in the wrench
bag. This screw can be used to tap threads in the holes in the main
Chassis and the bottom of the Diff Cover. Pre-tapping these holes
makes it easier to install the Screws during assembly.
BAG B (Continued)
122
31
122
31
20
7
122
29
Figure 12
15
20
122
26
32
5
27
26
15
11
31
31
7
11
Figure 13
27