Team Losi XXX-S Graphite Owner's Manual page 14

Step C-6
Servo Install
q
1. Install the servo into the Chassis (27) as shown in Figure 24.
The pins from both Servo Mounting Posts (55), (56) should fit into
the holes and sit flat against the Chassis.
q
2. Secure the servo to the Chassis with two 4-40 x 3/8" Flat Head
Screws (31).
Step C-7 Servo to Draglink Turnbuckle
57
q
1. Thread a Short Plastic Rod End (58) onto each end of the 4-40
x 5/8" Threaded Rod (57). Tighten both sides equally until the Turn-
buckle is the same length as the one shown in Figure 25B.
Step C-8
Servo to Draglink Turnbuckle Install
q
1. Attach the Rod End (58) to the Ball Stud (43) in the Servo Saver
Arm and the other to the Ball Stud in the Draglink (48) as indicated in
Figure 26.
BAG C (Continued)
31
58
Figure 24
11
27
Figure 25A
58
57
Figure 25B
Figure 26
58
57
48
53
55
31
43