Table of Contents
Advertisement
Specifying the draft (DRAFT)
Specify the draft when you wish to display the water depth below the sea
level, not the surface of the transducer.
The draft can be set in the range from 0.0 to 20.0 m or 20.0 unit.
The default value is 0.0 m.
Set the draft using the following procedure:
Display the FISH FINDER SETTING menu by pressing the
and
keys together.
Move control to "INITIAL SETTING" by pressing the
key, and display the INITIAL SETTING submenu by pressing the
key.
Move control to "CALIBRATION" by pressing the
and display the CALIBRATION submenu by pressing the
Move control to "DRAFT" by pressing the
Set the draft by pressing the
Example: 4.0 m (confirm the unit).
See page 49 for unit setting operations. Outline of the procedure:
Proceed from the FISH FINDER SETTING menu to "INITIAL
SETTING" first and then "UNIT".
Press the
key to return to the INITIAL SETTING submenu.
MARK
Press the
key to return to the fishfinding display.
GRAPH
Sea level
Draft
Surface of the transducer
or
or
key.
FISH FINDER SETTING INITIAL SETTING
or
or
key,
INITIAL SETTING
key.
key.
CALIBRATION
CALIBRATION
DRAFT UNIT
3.OPERATIONS 51
Advertisement
Table of Contents
