Error Conditions; Error Messages - Olivetti ECR 8200 S User Manual

E C
RROR ONDITIONS
Clearing an Error
Press to clear an error. The key tone ends, the displays clear and the keypad unlocks, allowing you to continue
with the transaction.
If an error condition cannot be cleared by pressing
reset operations.
Out-of-Paper
When the paper runs out, the message OUT OF PAPER appears on the operator display. Load the paper and press
to clear the error.
E M
RROR ESSAGES
The following error messages can be displayed:

Error Messages

OPERATION ERROR
SALES AMOUNT EXCEEDED
OR HALO ERROR
ZERO-PRICE ENTRY ERROR
FULL VOID AMOUNT
EXCEEDED
CLERK NOT LOGGED IN
NO PASSWORD ENTERED
TENDER AMOUNT
MANDATORY
PAPER ERROR
OUT OF PAPER
PRINTER HEADER
TEMPERATURE BECOMES
ABNORMAL
PRINTER CONTROL
VOLTAGE BECOMES
ABNORMAL
SD CARD FATAL ERROR
SD CARD NOT DETECTED
SD CARD WRITE
PROTECTION
SD CARD MEMORY FULL
SD CARD FILE NOT FOUND
SD CARD READ/WRITE
ERROR
GUEST NUMBER
MANDATORY
TABLE NUMBER
MANDATORY
, reset the cash register by performing one of the cash register
Description
Incorrect key entered. Press
Value entered exceeds that allowed and/or maximum value permitted by HALO
parameter.
Configuration does not allow zero-value prices.
Too many sales items entered before a Full Void operation.
Clerk System is active so Clerk number must be entered.
A password must be entered.
Entry of amount is configured as mandatory for the type of tender.
Paper roll not inserted correctly.
Paper finished, refill.
High printer temperature registered. Wait a few minutes then press
High printer voltage registered. Wait a few minutes then press
Irrecoverable error on SD Card. Replace card.
No SD card detected in slot. Check validity of card in slot. If new, try reformatting.
Data cannot be written onto SD card because it results as write-protected. Remove
write-protection and retry.
SD card is full. Replace or clear contents using EJ MEMORY CLEAR option.
No file found. Check SD card.
Cannot read from/write to SD card. If new, try reformatting.
For Table tracking, entry of Guest number is configured as mandatory.
For Table tracking, entry of Table number is configured as mandatory.
followed by to resume operation.
.
.
49