Volkswagen Golf Variant 2007 Maintenance Manual page 194

Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤
Maintenance - Edition 09.2009
The spark plugs are located below the ignition coils with output
stages.
– Remove connector -1- in direction of arrow, using assembly
tool -T10118- .
Note
It is necessary to remove the connector so that the ignition coils
with output stages, cables connected and the cable guide can be
laid to side.
– Remove all ignition coils with output stages -1- upwards using
puller -T40039- .
Note
When pulling out the ignition coils with output stages, the ca‐
♦
bles or the ignition coil connectors can remain connected.
Note installation position of ignition coils with output stages.
♦
– Carefully place ignition coils with output stages and cables
connected to side.
Caution
Ensure that the cables are not kinked or damaged.
– Unscrew spark plugs using spark plug socket and extension
-3122 B- .
Installing
– Screw in new spark plugs using spark plug wrench -3122 B-
and tighten to 20 Nm.
– Insert ignition coils with output stages in cylinder head and
align ignition coils in respective recesses of cylinder head cov‐
er.
– Push ignition coils with output stages onto spark plugs until
stop, they must be felt to engage.
– Connect connector onto exhaust recirculation valve until it no‐
ticeably engages.
Note
Ensure that the cable guide for ignition coils with output stages is
routed correctly.
– Install engine cover
190
4. Descriptions of work
⇒ page 105 .