Transporting Braces - Primus 6kg Installation And Maintenance Manual

WARNING!
! !
IF THE MACHINE IS LOCATED ON A HIGHER BASE FOR BETTER OPERATION, THE FRONT LEGS
OF THE MACHINE SHOULD BE LOOCKED FOR SAFETY REASONS (SEE FIG. 4.3.).
Do not forget to leave an access space to the lever of emergency door opening (fig.4.3.,pos.2), which is
located in the bottom left front machine part.
1. U-profile
2. Lever of emergency door opening

4.4. TRANSPORTING BRACES

There are two striking colour transporting braces which must be removed before putting the machine into
operation. Unscrew four bolts (1) on the rear panel of the washing machine. Before complete removal
of the rear panel it is necessary to disconnect the ventilation hose of the machine. It means loosen the hose
clip and pull the rubber hose off the plastic socket on the rear panel. Take down the rear cover. Unscrew nuts (3)
fastening braces (2) to the washing unit on the left and right up on high of the tub axis. Take out the braces (2).
Screw bolts (1) with nuts (3) back to the rear panel after brace removing. Braces (2) store out of a machine for cause
of later possible transport. When installing the rear cover again, don´t forget to put the rubber hose back
on the plastic socket and secure it with the hose clip.
1. Bolt joint of the brace
2. Transporting brace
3. Nut of the brace
8 INSTALLATION AND MAINTENANCE MANUAL
Fig.4.3. Bottom machine frame
Fig.4.4. Transporting braces
516574_C_PUB_DATE_3_NOV_2009.DOC