Enabling/Disabling Voice Prompts; Enabling/Disabling Plc (Packet Loss Consealment); Delete All Bluetooth Pairing Information - Sena SPH10S User Manual

However, even when this feature is enabled, if you
terminate intercom conversation manually with the
Jog Dial, you are not able to start intercom by voice
temporarily. In this case, you have to tap the Jog Dial
to restart the intercom. This is to prevent repeated
unintentional intercom connections by strong wind
noise. If you tap the Jog Dial to start an intercom
conversation, it is not terminated by 20 seconds of
silence. After turning SPH10S off and on, you can start
intercom by voice again.

9.3 Enabling/Disabling Voice Prompts

Voice Prompt
Factory Default
Enable
Disable
You can disable voice prompts by configuration setting,
but the following voice prompts are always on.
- Voice prompts for configuration setting menu
- Voice prompts for battery level Indicator
- Voice prompts for factory reset
"Voice prompt"
Enable
Tap the Phone Button
Tap the Jog Dial
9.4 Enabling/Disabling PLC (Packet Loss
Consealment)
Voice Prompt
Factory Default
Enable
Disable
The PLC (Packet Loss Concealment) algorithm is
enabled from the factory. It improves the audio quality
of the intercom and mobile phone handsfree in the
presence of data packet errors within the Bluetooth
link. It is recommend that this setting is always enabled.
However, if you feel that the audio from the intercom or
mobile phone is distorted in certain circumstances, you
may able to disable this setting and check it.

9.5 Delete All Bluetooth Pairing Information

Voice Prompt
Factory Default
Execute
To delete all Bluetooth pairing information of the SPH10S,
rotate the Jog Dial until you hear a voice prompt, "Delete
all pairings", and tap the Phone Button to confirm.
SPH10S
"PLC setting"
Enable
Tap the Phone Button
Tap the Jog Dial
"Delete all pairings"
N/A
Tap the Phone Button
13