Setting The Dual Camera Mode - Sony CCU-900 Installation And Maintenance Manual

5. The Return Matrix setup display appears.
The present allocated Return numbers are shown in
high light in the selection line.
n
The Return number to be allocated can be changed in
this state.
All the signals that can be allocated, are listed and the
list of signal names is shown in the center box. Select
the desired signal to be allocated using the MSU-
700A/750 knob, and press [Enter].
n
The present allocated signals are high lighted on
display.
Return Setting
Select
↓
SDI IN1
Return1
SDI IN2
SDI IN3
Return2
SDI IN4
SDI AUX
Return3
Camera
Analog IN1
Return4
Correspondence between the signal names in the box and
the actual signals is shown as follows.
Name in Actual selection signal
the selection box
SDI IN1 CCU rear panel SERIAL RET INPUT1
SDI IN2 CCU rear panel SERIAL RET INPUT2
SDI IN3 CCU rear panel SERIAL RET INPUT3
SDI IN4 CCU rear panel SERIAL RET INPUT4
SDI AUX CCU rear panel SERIAL AUX IN
CAMERA CAMERA picture
Analog IN1 CCU rear panel RET INPUT1
Analog IN2 CCU rear panel RET INPUT2
Analog IN3 CCU rear panel RET INPUT3
Analog IN4 CCU rear panel RET INPUT4
PROMPTER CCU rear panel PROMPTER IN
CCU-900/900P IMM

3-3-7. Setting the DUAL CAMERA MODE

When AUX IN and AUX OUT on the rear panel of the
unit are respectively connected to the BNC cable, two
CAMERA systems can be operated by using one fiber
cable. In this case, set the CCU connected by using the
fiber cable to Dual Mode: Primary and the CCU connected
by using the BNC cable to Dual Mode: Secondary.
Perform this setting on the setup menu of the unit or on the
configuration menu of the MSU-700A/750.
n
The AUX MATRIX setting of the CCU that is set to
Primary or Secondary is fixed to AUX and cannot be
changed. In addition, AUX1/2/3 cannot be switched from
the CA-950/950P. The Primary CCU and Secondary CCU
Exit
must be synchronized.
If setting the BVP-9500WS/9500WSP at the primary side
to the three-time speed when the dual system is operated
Enter
by the BVP-9500WS/9500WSP, the primary mode is
Cancel
released. In this case, the secondary system is not transmit-
ted.
Input
The BVP-9500WS/9500WSP at the secondary side cannot
be set to the three-time speed.
Setting on the setup menu of the unit
1. Set the MENU ON/OFF switch on the AT-122 board
2. Select "Others" from the setup menu entry display.
Rotary encoder
MIC LEVEL
NORM NORM MENU
OFF ON
POWER MIN MIN
CH-1 CH-2 ENTER CANCEL ENG PROD
MENU ON/OFF switch
panel to ON. The setup menu will be displayed.
* Setup Menu *
Return
AUX
PROMPT
PIX Out
WFM Out
ColorBars
>Others
3-3. Video Signal System
PGM SIDE
INCOM
TONE RTS CANCEL
MIX
SELECT
ENG PROD
PRIVATE
AT-122 board
3-11 (E)