Setting The Return Matrix - Sony CCU-900 Installation And Maintenance Manual

3-3. Video Signal System

3-3-6. Setting the RETURN MATRIX

Each input signal of the SERIAL RET INPUT1 to 4 and
SERIAL AUX IN connectors on the SDI-31 board rear
panel and that of RET INPUT1 to 4 and PROMPTER IN
connectors on the IF-730 board, can be allocated to RET1
to 4 selected from the camera side by using the RETURN
MATRIX function.
Perform this setting on the setup menu of the unit or on the
configuration menu of the MSU-700A/750.
Setting on the setup menu of the unit
Rotary encoder
MIC LEVEL
MENU
NORM NORM
OFF ON
POWER MIN MIN
CH-1 CH-2
1. Set the MENU ON/OFF switch on the AT-122 board
panel to ON. The setup menu will be displayed.
2. Select "Return" from the setup menu entry display.
* Setup Menu *
>Return
AUX
PROMPT
PIX Out
WFM Out
ColorBars
Others
3. Select the RET number to be allocated using the rotary
encoder and press the rotary encoder.
* Return *
>RET1 D-RET1 Active IN
RET2 D-RET2
RET3 A-RET1
RET4 A-RET2
4. The signals that can be allocated blink. Select the
desired signal using the rotary encoder and press
Enter. The signal to be allocated can be selected from
D-RET1/2/3/4, A-RET1/2/3/4, AUX, PROMPTER
and CAM.
For the details, refer to Section 2-2, "Setup Menu".
3-10 (E)
PGM SIDE
INCOM
TONE RTS CANCEL
MIX
SELECT
ENTER CANCEL ENG PROD
ENG PROD
PRIVATE
MENU ON/OFF switch
AT-122 board
Setting on the MSU-700A/750
1. Press the CONFIG button of the MODE block of the
MSU-700A/750 to light up the button.
The configuration menu will be displayed.
Configuration Menu
Camera
CCU
CNU MSU
2. Press [CCU].
The CCU configuration items will be displayed.
CCU Configuration
CCU BARS
Mode Set Char Set
Return
Setting
3. Select [Return|Setting] from the configuration items.
4. The Return Setting select display appears.
The allocating RET numbers appear in the selection
lines. The present allocated signals are displayed in the
neighboring frame.
In this state, press any of [Return1] through
[Return4] of the selection line for allocation.
Return Setting
Select
↓
Return1 Analog IN1
Return2 Analog IN2
Return3 SDI IN1
Return4
SDI IN2
Exit
Exit
CCU-900/900P IMM