Sony CCU-900 Installation And Maintenance Manual page 46

3-3. Video Signal System
3. Select "H-Phase" and adjust the H phase.
* Others *
>H-Phase
Y-Mix Gain
EEPROM Store
SEQ H/V
4. After adjustment, select "EEPROM Store" and save
the adjustment value.
How to adjust using the MSU-700A/750
1. Press the MAINTENANCE button of the MODE
block of the MSU-700A/750 to light the button.
The maintenance menu will be displayed.
Maintenance Menu
Adjusting CAM SW Auto
Setting Setup
Lens VCS
Adjusting Adjusting
SD Super
Adjusting Motion
2. Press [Adjusting].
The maintenance adjustment menu will be displayed.
Clear
VBS Camera
Phase
Level Output
Black
White
Shading BlackSet
Shading
3. Press [Phase] to highlight the button.
The phase adjustment display will appear on the lower
side of the display.
4. Press [H] to highlight the button.
The H phase adjustment display will be displayed.
H Phase
H SC
H-Coarse
3-6 (E)
45
7
H
Exit
Exit
SDI
Output
1
2
OHB
Matrix
H-Fine
0
5. Adjust the H phase using the control conforming to the
display item.
Phase : Adjustment of H phase
How to end the adjustment
Press the MAINTENANCE button to turn it off.
Adjusting the Color Frames between the CCU Systems
This unit does not synchronize with the sub-carrier. Therefore,
when plural CCU-900/900Ps are connected in parallel, be
sure to adjust the color frames between the CCUs.
Perform this operation on the setup menu of the unit or on
the maintenance menu of the MSU-700A/750.
n
Do this operation every time after turning on the power of
the unit.
How to adjust on the setup menu of the unit
Rotary encoder
MIC LEVEL
MENU
NORM NORM
OFF ON
POWER
MIN MIN
CH-1 CH-2
1. Set the MENU ON/OFF switch on the AT-122 board
panel to ON. The setup menu will be displayed.
2. Select "Others" from the setup menu entry display.
* Setup Menu *
Return
AUX
PROMPT
PIX Out
WFM Out
ColorBars
>Others
3. Select "CF Shift" and press the rotary encoder.
Each press of the rotary encoder shifts the color frame
output from the PIX1/2 and WF1/2 connectors on the
rear panel of the unit by one frame. Adjust the color
frame until the color frames of all the CCU outputs are
synchronized.
* Others *
Reference Analog
Dual Mode Normal
FRONT PGM PGM1
PGM INPUT SERIAL
SDI AUDIO ON
>CF Shift
PGM SIDE
INCOM
TONE RTS CANCEL
MIX
SELECT
ENTER CANCEL ENG PROD
ENG PROD
PRIVATE
MENU ON/OFF switch
AT-122 board
CCU-900/900P IMM