1-5. Settings of Switches and Controls on Boards
. S1109 (frame interpolation)
5
When operating in the super motion mode, select the
CCU-900/900P standard output mode (for SERIAL
OUTPUT 1/2/3, SERIAL MONITOR OUTPUT, PIX1/2
and WF1/2 connectors of the rear panel).
The CCU-900/900P can perform the normal speed video
signal output with minimum unnatural movement from
the three-time speed video signal.
n
Each of the A, B and C modes is the same as the modes
(A, B, C) that can be set on the super motion setting
menu of the MSU-700A/750.
0
REMOTE : Controlled by the MSU.
1
A mode :
Standard interpolation ratio
2
B mode :
Set when the motion speed of object is high
and the video signal is unnatural with the
setting “A”.
3
C mode :
Set when the motion speed of object is slow
and the video signal is unnatural with the
setting “A”.
4 to 8
Not used. Do not set these.
9
OFF :
Interpolation is not used.
The three-time speed video signal that is the
same as the output signal from the SS-A
connector on the rear panel is output as the
CCU standard output.
Factory setting : 0 (REMOTE)
However, if the MSU is not connected, the unit is put
into the same mode as “1 : A mode”.
1-15 (E)