ProCurve 2610 Manual page 376

Configuring Port-Based and User-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
11-52
show port-access authenticator (Syntax Continued)
config [< port-list >]
Shows:
• Whether port-access authenticator is active
• The 802.1X configuration settings of ports
configured as 802.1X authenticators (For a
description of each setting, refer to the syntax
descriptions in "2. Reconfigure Settings for Port-
Access" on page 11-20. Use show running to view the
current client-limit configuration available for
switches.)
Without <port-list>, the command lists ports configured
as 802.1X port-access authenticators. Does not display
data for a port not enabled as an authenticator.
statistics [< port-list >]
Shows:
• Whether port-access authenticator is active
• The statistics of the ports configured as 802.1X
authenticators, including the supplicant's MAC
address, as determined by the content of the last
EAPOL frame received on the port.
Does not display data for a specified port that is not
enabled as an authenticator.
session-counters [< port-list >]
Shows whether port-access authenticator is active, and
includes the session status on the specified ports con­
figured as 802.1X authenticators
Also, for each port, the "User" column lists the user
name the supplicant used in its response packet. (For
the switch, this is the identity setting included in the
supplicant command—page 11-48.) Does not display
data for a specified port that is not an authenticator.
vlan [< port-list >]
Shows per-port:
The Access Control setting (control command on
■
page 11-20)
■ Unauth-VLAN ID (if any)
■ Auth-VLAN ID (if any)