Command Prompts; Screen Simulations; Port Identity Examples - ProCurve 2610 Manual

Getting Started
Conventions
1-6

Command Prompts

In the default configuration, your switch displays the following CLI prompt:
ProCurve Switch 2610#
To simplify recognition, this guide uses ProCurve to represent command
prompts for all models. For example:
ProCurve#
(You can use the hostname command to change the text in the CLI prompt.)

Screen Simulations

Figures containing simulated screen text and command output look like this:
ProCurve> show version
/sw/code/build/info
Image stamp:
Nov 2 2007 13 43:14
R.01.XX
430
ProCurve>
Figure 1-1. Example of a Figure Showing a Simulated Screen
In some cases, brief command-output sequences appear outside of a
numbered figure. For example:
ProCurve(config)# ip default-gateway 18.28.152.1/24
ProCurve(config)# vlan 1 ip address 18.28.36.152/24
ProCurve(config)# vlan 1 ip igmp

Port Identity Examples

This guide describes software applicable to both chassis-based and stackable
ProCurve switches. Where port identities are needed in an example, this guide
uses the chassis-based port identity system, such as "A1", "B3 - B5", "C7", etc.
However, unless otherwise noted, such examples apply equally to the
stackable switches, which for port identities typically use only numbers, such
as "1", "3-5", "15", etc.