Regulatory Information (From F50); Canadian Radio Interference Regulations - Canon MultiPASS F50 User Manual

F50 Chapter 10.qxd 06/01/2001
Turning the F50 Off
To avoid printer malfunction always use the ON/OFF button to turn the printer on and off. Never remove the
power cord from the power outlet until you have turned off the printer by pressing the ON/OFF button. Once
off, you can unplug the power cord from the power outlet.
Using the Printer Near Appliances and Fluorescent Lamps
Allow at least 6 inches clearance between the printer and another appliance or a fluorescent lamp. Electrical
noise generated by a fluorescent lamp placed too close to the printer could cause the printer to malfunction.

Regulatory Information (from F50)

Color Printer Model K10206 ( (F50)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of a shielded cable is required to comply with Class B limits in Subpart B of Part 15 of the FCC Rules.
Do not make any changes or modifications to the equipment unless otherwise specified in the manual. If such
changes or modifications should be made, you could be required to stop operation of the equipment.
Canon U.S.A. Inc.
Digital Home and Personal Systems Division
2995 Red Hill Avenue
Costa Mesa, CA 92626
1-800-423-2366

Canadian Radio Interference Regulations

This digital apparatus does not exceed Class B limits for radio noise emissions from a digital apparatus as set
out in the interference-causing equipment standard entitled "Digital Apparatus", ICES-003 of the Industry
Canada.
Cet appareil numérique respecte les limites de bruits radio éléctiques applicables aux appareils numériques
4:09 PM Page 77
Never touch the printhead or electrical contacts on a printhead immediately after removing it
from the printer. These metal parts become very hot during printing and could cause minor
burns.
[NEW NUMBERS NEEDED]
77