Pci And Pci-X Cards; Figure 4-7 Pci And Pci-X Card Slots In The Base Compute Module - Silicon Graphics Prism Visualization System User Manual

PCI and PCI-X Cards

CONSOLE L1 PORT
007-4701-003
Your base compute module and various optional modules in your system support PCI
and PCI-X cards. The following instructions, which describe how to install and remove a
PCI or PCI-X card from system base compute module, can be used to install and remove
PCI and PCI-X cards from the base compute, CPU expansion, or CMPX module. For
specific information on removing or replacing XG2N graphics cards, see "Replacing an
XG2N Graphics Card" on page 91.
Figure 4-7 shows the location of the PCI and PCI-X card slots in the base compute
module.
For an updated list of supported PCI and PCI-X cards, see SGI Supportfolio at
http://support.sgi.com.
This section describes the following:
• "Rules for Card Installation and Removal" on page 82
• "Installing a PCI or PCI-X Card" on page 83
• "Removing a PCI or PCI-X Card" on page 87
NUMALINK 0 CPU
Figure 4-7 PCI and PCI-X Card Slots in the Base Compute Module
PCI 4
PCI 3
PCI 2
NUMALINK 1
PCI 1
PCI and PCI-X Cards
PCI/PCI-X slots:
Bus 2, slot 2
(with USB)
Bus 2, slot 1
Bus 1, slot 2
(with ImageSync)
Bus 1, slot 1
(with IO10)
81