Preparing The Module; Figure B-3 Attaching Optional Chassis Rails To The Module Chassis - Silicon Graphics Prism Visualization System User Manual

Preparing the Module

!
007-4701-003
To attach the chassis rails to the module, follow these steps:
1. Place the module on a flat, stable surface.
2. Using four 10-24 x 1/4-inch screws, attach one of the chassis rails to the right side of the
module chassis. Ensure that the rail is installed in the correct direction (see Figure B-3).
Caution: Use only the 1/4-inch (0.64 cm) length screws. Longer screws damage internal
components in the module.
3. Using five 10-24 x 1/4-inch screws, attach the second rail to the left side of the module
chassis. Again, ensure that the rail is installed in the correct direction.
Figure B-3 Attaching Optional Chassis Rails to the Module Chassis
Using Silicon Graphics Prism Modules with a Rack
2
TM
185