McQuay MDS030AR Applications Manual page 68

Design & installation Guide For McQuay MDS Multi System
-68-
BACK
FRONT
FRONT
BACK
600mm
Handling outdoor units
Please refer to the followings to move units; To use 4 supporting points to move units instead
of 3 points, to avoid unstable move and units drop off.
Protective pads
Notes:
Be careful in the moving of outdoor units.
Do not lift or move units with the package rope, as it is easy to
break and bring danger.
Do not directly touch the fins of units to avoid hurt of hand.
Do keep the plastic bag from the child.
Outdoor unit installation
To use concrete or supporter to build a base. Fully consider the floor strength, drainage
(discharge from the unit in operation), and pipes and cables layout. If the strength
cannot satisfy the requirement, the unit may fall off to damage the unit and injure
people.
To fix the outdoor unit with screw bolt to avoid falling off by earthquake or strong wind.
Properly install the unit to defend against strong wind and earthquake better.
To take some shock resistance measures (such as using cushion and bumper bracket)
to avoid vibration passing to the installation part. The bottom panel and wall may cause
vibration and noise, depending on the installation condition.
To place the edge to the right position. Otherwise, the unstable unit may cause the
installation foot bent. Any improper installation may cause the unit falling off and injuring
people.
Warning:
The unit must be installed to the place which is strong enough to bear the unit weight
and vibration.
For lower pipes and cables layout, make sure the base not block the hole at the bottom.
When laying out the lower pipes, the basic height shall not be less 100 mm to ensure
the pipe to get through the unit bottom.
BACK
FRONT
FRONT
BACK
Suspension ropes
(2 ropes)
<40
>8 m
BACK BACK
FRONT FRONT
FRONT FRONT
BACK BACK
< 40
>8m